Manlifts are a means of elevating an employee to a certain height by means of its scissor lift and allowing him to do his job there. Depending on the specification of the vehicle, a lift can reach a height from 8 meters to 22 meters. Platform dimensions can also be between 3 meters and 5 meters, as required by the job. In addition, platforms may have elongation and shortening properties.

Manlift on, battery or diesel engine. It is more suitable for working on flat floors. They are generally preferred in construction sites with a flat surface. They are also used frequently in loading areas or in factories. It is preferred for high welding or roller painting. In a sense, it acts as a mobile scaffold. In unexpected situations such as excessive wind or other vibrations, overloading or impact, manlifts lock themselves. In this way, possible accidents are prevented.

Especially because it will work on human during use human health ve employee safety risky vehicles. Annex to the Regulation on Health and Safety Conditions in the Use of Work Equipment issued by the Ministry of Labor and Social Security, Annex 3 Maintenance, Repair and Periodical Controls Lifting and forwarding tools showed in the group. In this way, unless otherwise specified in other regulations, periodic inspections and inspections of the lifters shall be carried out at least once a year.

The important point is that the controls and inspections to be carried out must be carried out by authorized persons. Neither checks nor reports shall be deemed valid if control and inspection procedures are not performed by mechanical engineers, mechanical technicians or higher technicians as described in the Regulation.

Prior to the inspection, the previous inspection reports of the lifts are examined. If there are any nonconformities detected before, it is checked whether they are resolved. The lifts are then visually checked. Check whether there is a visible defect or a problem with the connections. Mechanical and functional controls are then carried out. It is checked whether it performs the expected functions with or without load.

The Regulation also specifies the standards to be considered during these checks as follows:

  • TS 10116
  • TS EN 280
  • TS EN 818-6 + A1
  • TS EN 1495 + A2
  • TS EN 1709
  • TS EN 12079-3
  • TS EN 12927-7
  • TS EN 13157 + A1
  • TS EN ISO 13534
  • TS ISO 789-2
  • TS ISO 3056
  • TS ISO 4309
  • TS ISO 7592
  • TS ISO 9927-1
  • TS ISO 11662-1
  • TS ISO 12480-1
  • TS ISO 12482-1
  • FEM 9.751
  • FEM 9.752
  • FEM 9.755
  • FEM 9.756

The TÜRCERT certification body provides conformity assessment, certification and training services, while providing testing and inspection services. Do not hesitate to contact the experienced managers and employees of the TÜRCERT certification body for further information on inspection and inspections of manlifts.